Use & care guide

12
o GREEN LIGHT TURNS OFF AFTER FLASHING – Battery is faulty,
exhausted and or is no longer rechargeable. Prompt dispose of these
batteries to avoid eventual battery leakage.
o RED LIGHT ON – USB or DC-OUT ports on active mode when there are
devices connected to these ports on the charger.
o RED LIGHT OFF – No Devices connected to the USB or DC-OUT ports.
STEP 4: INTERACTION WITH LCD CONTROL PANEL.
o CHANNEL SELECT BUTTON - when pressed will move the focus
point of the LCD screen from the left to the right channel in succession
and the cycle repeats as follows:
Æ CHANNEL 1 ð CHANNEL 2 ð CHANNEL 3 ð CHANNEL 4 Ê
The selected channel shows the charging status and voltage condition
of the battery in it under the STATUS heading.
o DC-OUT SELECT BUTTON - when pressed the variable DC voltage
output at the back of the charger changes from lowest to highest level
in succession and the cycle repeats as follows:
Æ 4.2V ð 6V ð 8.4V Ê
The selected DC voltage output is regulated at a set level to match the
required power input setting of the appropriate digital device being
powered or charged.
DC-OUT CHARGING FUNCTION
The REZAP
®
PRO is equipped with a variable voltage, DC-OUT socket at
the back of the charger. This socket outputs three different preset regulated
voltage levels of 4.2V, 6V and 8.4V which can be selected by the DC-OUT
select button, located on the control panel. Linking via a 1-IN, 6-OUT multi-
headed DC-OUT cable (described in details on page 5), allows the charger
to power a range of otherwise unpowered devices or charge up different
battery packs in many self-powered devices.
ENGLISH