Use & care guide

www.procontechnology.com.au Phone: [phone] FAX: [phone]
H
S
I
L
G
N
E
N
G
L
ISH
TESTER FUNCTION
The charger has a built-in battery tester, which measures voltage level o f
batteries, one at a time, and displays their strength using the 4 green ligh t s .
When a battery, to be tested, is placed into the tester slot with the rest of t he
remaining slots being empty, the voltage level of the battery is displayed f or
about five seconds and if the battery is not removed from the tester slot,
automatic charging will proceed. In tester mode, the 4 x Green lights move
horizontally from left to right indicating the following condi t ions :
o No Green light - battery is dead or voltage is extremely l ow .
o 1 x Green light - Very Low strength vo l tage ,
o 2 x Green lights - Low strength vo l tage ,
o 3 x Green lights - Medium strength vo l tage ,
o 4 x Green lights - High strength voltage.
NOTES
•
The tester shows only maximum 3 Green lights for rechargeable
batteries when “full” as their voltage rating is 1.2V instead of 1.5V of
alkaline ba tt eries .
• Some exhausted and or faulty alkaline batteries show a false vol t age
of up to 1.5V or higher when measured by means of a volt meter or t he
built-in tester, however when you put these to use, they quickly die .
These batteries should also be disposed of immediately to avoid
eventual battery leakage .
CLEANING
Turn the power off and remove the plug before cleaning the charger .
• The Plastic Body can be cleaned with a lightly damp cloth and then
wiped dry with a soft cloth. Do not use any abrasive clothes or solvents on
any plastic sur f ace .
• The battery compartment contacts can be cleaned using a piece of clo t h
dampened with Methylated Spirits solvent (available from most hardware
stores). Alternatively a clean pencil eraser can be utilised to rub off any
dirt and or deposit that might adhere to
t hem .