Use & care guide

www.procontechnology.com.au Phone: [phone] FAX: [phone]
NGL
IS
H
5. The green light does not turn on or blink even when there is a
battery in the s l ot .
• Loose or bad contact between the battery and the metal plate in the slo t
may exist, reinsert the battery properly or gently move or rotate t he
battery until good contact is established. If the LED remains off, t ry
relocating the battery to a different slot to ensure problem is not caused
by the slot. Should the LED still not respond, the battery is dead due t o
internal open circuit or chemical / rust deposit at its terminals. Remove
and dispose of the battery thoughtfully. The battery contacts may also be
dirty. Refer to the cleaning section for cleaning procedure .
6. Charger rejects many batteries. How to verify that the charger is
work i ng proper l y .
• There are two simple tests to verify if the charger is functioning properly
or not. If it passes the tests below, then the charger is working as i t
should .
o Put a NEW (fresh from a packet) AA alkaline battery into the charger .
After a short while, the green light should turn ON constant indica t ing
the battery is detected as "FULL".
o Put a known good-condition NiMH AA rechargeable battery into t he
charger. The green light should be blinking away for at least 10
minutes, indicating that the battery is recognized as “rechargeable”
and charging continues until the battery is fully recharged .