Installation & Quick Start Guide WL400 Wireless Adaptor/Antenna QUICK START WL400-01- VR1.1 www.busse-yachtshop.de | info@busse-yachtshop.
WL400 Quick Start Guide DIGITAL ALLTEK 1. Introduction Congratulations on the purchase of your WL400 Wireless Adaptor/Antenna. This unit is designed for permanent or semipermanent installation on sail or motor vessels. The base of the WL400 is threaded and designed to be screwed in to a suitable 1” x 14 TPI threaded VHF antenna mounting bracket (not supplied). Before operating the unit you should familiarise yourself with the complete user manual supplied with the product. 2.
WL400 Quick Start Guide DIGITAL ALLTEK 4. Driver/Software Installation It is very important that you do not plug the WL400 in to a USB port on your computer unless you have the WL400 Drivers USB Memory Stick or CD-ROM close to hand. By plugging in the WL400 you will initiate the Windows “Found New Hardware Wizard” which will not be able to complete correctly without the Drivers on the USB Memory Stick or CD-ROM being present.
WL400 Quick Start Guide DIGITAL ALLTEK Now that the Realtek drivers are installed, you can connect the WL400 to the computer by plugging in the USB connector in to a spare USB port. Windows should now start the “Found New Hardware” wizard and a pop-up will be displayed on the task bar in the bottom right corner of the screen. After about 10-20 seconds, the pop-up should show a “New Hardware Installed Successfully” message.
WL400 Quick Start Guide DIGITAL ALLTEK Figure 5 Figure 9 Figure 10 Installation for Apple Mac OS X Insert the WL400 Drivers/Software USB Memory Stick or CD-ROM in to your Apple Mac and using Finder open the folder called MacOS10.4 or MacOS10.3 depending upon the version of Mac OS X you have. Included in each of these folders is an Install.mpkg package that you can double click on to install.