Technical data

Connecting SCSI Adapters
8-2
Single Channel SCSI Configuration
To connect SCSI devices, perform the following:
1.
Power down the server.
2.
Disconnect all peripheral devices from the server.
3.
Unlock and remove the side panel.
4.
Connect the cables as shown in Figure 8-1.
5.
Replace and lock the side panel.
6.
Connect all external devices and then power on your server.
7.
Run the SCU utilities to configure your server.
Refer to Chapter 2, “Server Software and Utilities,” and to your SCSI documentation
for additional configuration information.
Figure 8-1 Legend Component
A External wide SCSI 67-pin terminator
B External wide SCSI 67-pin connector
C Wide SCSI 67-pin connector to CD-ROM drive (option on XLe 6000
configuration)
D 67-pin to 50-pin SCSI adapter
E Wide SCSI 67-pin connector to tape drive
F Wide SCSI 67-pin connectors (for internal SCSI devices)
G Wide SCSI 67-pin connector to SCSI hard disk drive
H Adaptec 7880 wide SCSI 67-pin connector to main logic board