User`s guide
Table Of Contents
- Table of Contents
- About This Guide
- Introduction
- Server Front/Rear Panel Controls and Indicators
- Server Utilities
- Introduction
- SCSI Select Utility
- Flash Utility
- Using EPP3SMC.EXE
- System Configuration Utility (SCU)
- Configuring Expansion Boards
- Locating the SCU
- When to Run the SCU
- SCU Keyboard Function Keys
- Starting and Using the SCU
- Configure Your Computer
- Setting the Date and Time
- Maintain the SCU Diskette
- SCU Options
- System
- Diskette Drive Group
- Hard Disk Group
- Serial Port Group
- Parallel Port Group
- Video Options Group
- Shadow Options Group
- Cache Options Group
- Miscellaneous
- SCSI Options Group
- PCI Slot Options Group: (PCI Slots 1-3)
- Expanding Your Server
- Introduction
- Tools Needed
- Static Electricity
- Disconnect External Devices and Power
- Removing the Side Panel
- Server Components
- Main Logic Board Components
- Upgrading the CPU Module
- Upgrade Sockets and Jumper Locations
- Installing Additional Secondary Cache Memory (i486 CPU Modules)
- Installing Additional Server Memory
- Installing a SIMM
- Replacing the Server Battery/Real Time Clock (RTC)
- Installing Video Memory
- Installing Expansion Boards
- Adding Mass Storage Devices
- SCSI Configuration Guidelines
- Expansion Brackets
- Installing a Device into the Front Access Drive Bay
- Installing a Device into the Internal Drive Bay
- Connecting Diskette and IDE Devices
- Connecting SCSI Devices
- External SCSI Bus Guidelines
- A-E
- F-S
- T-Z
- Problem Solving and Troubleshooting
- Server Security Features
- Appendix A: Technical Specifications
- Appendix B: Server Messages
- Appendix C: Device Mapping
- Appendix D: Caring For Your Server
- Index
FCC ID: A09-PC79X
The FCC wants you to know...
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
Any changes or modifications made to this equipment may void the user's
authority to operate this equipment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
The user may find the following booklet prepared by the Federal
Communications Commission helpful:
How to Identify and Resolve Radio-
TV Interference Problems.
This booklet is available from the U.S.
Government Printing Office, Washington, D.C., 20402. Stock No. 004-
00398-5.
All external cables connecting to this basic unit need to be shielded. For
cables connecting to option boards, see the option manual or installation
instructions.
This digital apparatus does not exceed the Class B limits for radio noise
emissions set out in the radio interference regulations of the Canadian
Department of Communications.