Specifications

SF200 Manual
SF200E-0160-01 REV 04
Diane Smith
4/22/13
Page 16 of 28
4.5 You can now power up and use the SF-200.
4.5.1 Verify that the SF-200 is powered on.
(front LED will be green)
No LED or red LED indicate insufficient power.
4.5.2 Verify that the monitor has power and turned on.
4.5.3 Wait for the Grey Scale image to be displayed.
The image will also show what IP address the SF-200 is
connected to, and what resolution it is set to.
5. Network Connection
5.1 Network that is setup for DHCP (to automatically assign IP
Addresses).
5.1.1 The SF-200 default mode is DHCP enabled. So when
booted up, the SF-200 should be assigned an IP address
from the Network and this IP Address will be displayed as
part of the Grey Scale image.