Owner`s manual

2.2 Site Preparation
No special site preparation is required, although peripherals operating in
office areas can be affected by static discharge, temperature changes, and
extremes of humidity. These conditions may cause poorer operation and
decrease the dependability of the TSZ07 Tape Drive. Good site planning
will decrease these effects and ensure dependable operation. Use the site
preparation data sheets in the Site Environmental Preparation Guide for
information on environmental conditions that can effect the TSZ07 Tape
Drive.
The TSZ07 Tape Drive is equipped with a cooling fan to maintain a
safe internal operating temperature. The power supply has an over-
temperature sense circuit which disables all power supply output when
activated. Cycling the rear panel ac power switch restores normal
operation.
So that air flow is not restricted, a minimum clearance of two inches
is required at the tape drive’s rear panel. The front panel must not be
covered.
2.3 Installing the Table Top Models (TSZ07-CA, -FA)
Installation of the table top TSZ07 requires the following:
1. Unpacking the TSZ07.
2. Unpacking the accessories box.
3. Installing the cables.
When these procedures are complete you can operate the TSZ07 (see
Chapter 3 for operating information).
2.3.1 Unpacking the TSZ07-CA, -FA
The table top TSZ07 is shipped in one large and one small carton. The
large carton contains the TSZ07 tape transport. The smaller carton
contains documentation, a cleaning kit, a SCSI cable, a power cord, and
a reel of magnetic tape. There is a SCSI terminator mounted on the rear
of the TSZ07.
Remove the TSZ07 and all other items from the shipping carton and
place the TSZ07 on a flat surface. After unpacking the TSZ07, check the
shipping documents to ensure that the correct model has been shipped.
2–2 Installation