Owner`s manual

You can now remove the packing ring from the take-up hub.
To close the table top TSZ07 enclosure, perform the following:
1. Lift the cover retaining arm (see Figure 2–3).
2. Close the top cover of the tape drive.
3. Close the enclosure lid by releasing the latch (see Figure 2–2), closing
the lid, and pushing down on the top front corners of the enclosure
lid until the latch engages.
2.3.3 Unpacking the Accessories Carton
Open the accessories carton and remove its contents. Check that the kit
contains the following:
• TSZ07 Tape Drive Installation/Owner’s Manual
• TSZ07 Tape Drive Technical Manual
• Tape cleaning kit
• Magnetic tape (2400 feet, blank)
• SCSI data/control cables (BC06P-06, BC56H-06, BC13N-25)
• Country specific ac power cord
• FTZ postcard (German kit)
If any item is damaged, missing, or incorrect, contact the dealer from
whom the system was purchased.
2.3.4 Installing the Cables on the TSZ07-CA, -FA
To operate the TSZ07, you must first connect the SCSI connector cable
and the power cable.
2.3.4.1 SCSI Cabling
Bus terminators are required at each end of the SCSI bus. When the
TSZ07 is configured as the last device on the SCSI bus, a terminator
must be installed on the open connector (see Figure 2–4). A terminator
is installed on the TSZ07 when shipped.
2–6 Installation