Owner`s manual

You can now remove the packing material from the take-up hub (see
Figure 2–3).
To close the TSZ07 cabinet enclosure, perform the following:
1. Lift the cover retaining arm.
2. Close the top cover of the TSZ07.
3. Close the cabinet lid by releasing the latch and placing the lid in the
closed position.
2.4.7 Opening the Cabinet TSZ07, Alternate Method
To pull the TSZ07 from the cabinet perform the following:
WARNING
Before you do the first step, ensure that the cabinet is
stabilized by extending its support leg before pulling
the drive out of the cabinet on its slides.
1. Remove the shipping bracket from the rear of the tape drive.
2. Reach underneath the left corner of the front panel through the air
inlet and open the rack latch. See Figure 2–14.
3. Pull the drive out of the cabinet.
4. Raise the top cover and place the cover retaining arm in the recess
next to the tape path. See Figure 2–14.
Reinstall the drive into the cabinet as follows:
1. Lift the cover retainer arm.
2. Close the top cover.
3. Press the lock in each slide inward and push the drive into the
cabinet.
2–24 Installation