Owner`s manual

2.5.3 Unpacking the Accessories Carton
Open the accessories carton and remove its contents. Check that the kit
contains the following:
• TSZ07 Tape Drive Installation/Owner’s Manual
• TSZ07 Tape Drive Technical Manual
• Tape cleaning kit
• Magnetic tape (2400 feet, blank)
• SCSI data/control cables (BC06P-06, BC56H-06)
• Country specific ac power cord
• FTZ postcard (German kit)
2.5.4 Installing the Rackmountable Tape Drive (TSZ07-AA,
-DA)
Installation of the Rackmountable Tape Drive (TSZ07-AA, -DA) consists
of installing the TSZ07 in a standard 19-inch EIA rack (cabinet). After
the TSZ07 is installed, the interface and power cables must be connected.
2.5.5 Installing the Slides on the Rack
To install the slides on the rack for the installation of the TSZ07 perform
the following:
WARNING
Use sufficient people to lift the TSZ07.
1. Remove the TSZ07 from the shipping container and set it on a flat
work surface.
2. Slide the rails to the rear of the TSZ07 until the rail locks in position
(see Figure 2–16).
2–28 Installation