Owner`s manual

6. Place the L bracket at the rear of the rails between the cabinet
mounting rail and the slide rail.
7. Install 2 screws and bar nut through the L bracket to mount the slide
rails to the cabinet rear mounting rail. Do not tighten the screws yet.
8. Repeat steps 2 through 7 for the other slide rail on the TSZ07.
9. Pull the rails forward until they lock in position, fully extended.
WARNING
If there is a safety foot with this rack, be sure it is
fully extended before installing the TSZ07.
10. Lift the TSZ07 and carefully position the slides in the rails and slide
the TSZ07 until it locks in position.
11. Press the button lock to release the TSZ07 and then push it into the
operating position - the latch catches. Tighten all screws and hex
nuts now.
12. Slide the TSZ07 to the fully forward position. Make sure the unit
slides smoothly. Adjust the hex nuts and screws to ensure smooth
operation.
13. Install the SCSI and power cables. Be sure to provide a strain relief
for the cables.
14. Push the safety foot back into position.
NOTE
This procedure may not be applicable for a non-Digital
standard cabinet.
2.5.6 Installing Cables on the TSZ07-AA, -DA
To install the cables on the rackmountable TSZ07, connect the SCSI cable
and the power cable using the procedures recommended for that rack
and the requirements of Section 2.3.4. When the cables are installed the
TSZ07 is ready for operation (see Chapter 3 for operating information).
2–30 Installation