Owner`s manual

Table 3–2: Error Messages
Messages Problem/Action Required
Door ajar Close the front door.
End of media Tape is full; another is required.
Hub seat Verify that the tape reel is seated on supply hub.
ID unknown Tape format cannot be read.
Interface error Switch off power, then switch on; try operation again.
Load error Check tape leader; try loading again.
Machine error Switch off power, then switch on; try operation again.
Manual peel Re-crimp leader and retry using the "Loading High-
Static Tapes" section.
Motor fault Switch off power, then switch on; try operation again.
No BOT Check BOT marker on tape.
No door lock Close front door.
Not enough tape on
take-up
Reload; may require manual load.
Read error Switch off power, then switch on; try operation again.
Read only tape Write-enable ring needed to write.
Reel upside-down Write-enable ring side of reel must be down.
Trap Switch off power, then switch on; try operation again.
Write error Switch off power, then switch on; try operation again.
Write retry
exceeded
Bad tape; try another tape.
Operation 3–17