Technical data

2–2 Write-Enable Ring ...............................................2–8
2–3 Tape Reel Insertion ..............................................2–9
2–4 TSZ07 Tape Path ...............................................2–11
3–1 Location of Tape Path and Sensors . . ................................3–2
3–2 Location of Air Filter .............................................3–3
4–1 Assigned Numbers of Control Panel Switches . . ........................4–9
5–1 Operator Access Position . . ........................................5–5
5–2 Location of Retaining Screws .......................................5–7
5–3 Service Access Position . . . ........................................5–8
5–4 Removing the Blower............................................5–11
5–5 Removing the Control Switch Circuit Board . . . .......................5–12
5–6 Removing the Door..............................................5–13
5–7 Removing the Door Lock . . .......................................5–14
5–8 Removing the EOT/BOT Sensor Assembly ............................5–15
5–9 Removing the File-Protect Sensor . . . ...............................5–16
5–10 Removing the Front Panel . .......................................5–17
5–11 Removing the Front Panel Display Circuit Board ......................5–19
5–12 Removing the Head Circuit Board . . . ...............................5–21
5–13 Removing the Hub Lock Solenoid...................................5–23
5–14 Removing the Input Air Duct ......................................5–25
5–15 Removing the Interface Circuit Board ...............................5–27
5–16 Removing the Interlock Switch ....................................5–28
5–17 Removing the Left Output Air Duct . . ...............................5–29
5–18 Removing the Manual Release Switch ...............................5–30
5–19 Removing the Packer Arm . .......................................5–31
5–20 Removing the Plenum ...........................................5–33
5–21 Removing the Power Supply ......................................5–35
5–22 Removing the Read/Write Formatter Circuit Board .....................5–37
5–23 Removing the Read/Write Head ....................................5–38
5–24 Removing the Right Output Air Duct ...............................5–40
5–25 Removing Roller Guide 1 . . .......................................5–41
5–26 Removing Roller Guide 3 or 4 .....................................5–42
5–27 Removing Roller Guide 5 . . .......................................5–43
5–28 Removing the Servo Circuit Board . . . ...............................5–45
5–29 Removing the Supply Hub . .......................................5–46
5–30 Removing the Supply Hub Bell Crank ...............................5–47
5–31 Removing the Supply Motor .......................................5–49
5–32 Removing the Take-Up Hub .......................................5–51
5–33 Removing the Take-Up Motor .....................................5–53
5–34 Removing the Tape-in-Path Receiver . ...............................5–54
5–35 Removing the Tape-in-Path Transmitter .............................5–55
5–36 Removing Tension Sensor/Roller Guide 2 .............................5–57
vii