Technical data

5.4.31 Take-Up Motor (P/N 29-28469-01)
To remove the take-up motor, refer to Figure 5–33 and proceed as follows:
1. Remove the take-up hub (Section 5.4.30) and the plenum (Section 5.4.17) or the plenum
access panel, depending on the configuration.
2. Disconnect the two connectors ( and ) from the motor .
3. Loosen the four screws securing the take-up motor to the deck plate.
4. Hold the motor while removing the four screws , then remove the motor.
To replace the take-up motor, proceed as follows:
1. Perform the removal procedure in reverse order.
2. Perform the Take-Up Hub Adjustment (refer to Section 6.5).
5–52 Removal/Replacement Procedures