Technical data

5.3.2 Service Access for the Table-Top Drive
To place the tape drive in the service access position, proceed as follows:
NOTE
Step 1 applies to early versions of the TSZ07 which have latches that engage
the top cover. If these latches are not present, proceed to step 2.
1. Push down on the top front corners to release the latches, then lift the enclosure lid.
2. Raise the top cover and place the cover retainer arm in the recess next to the tape path.
3. Locate and loosen the two retainer screws on the deckplate (shown in Figure 5–2).
4. Fold the cover retaining arm out of the way and close the top cover.
5. While grasping the bottom of the front panel, lift upward. When the gas strut is fully
extended, the safety support automatically locks the deck plate in the service access
position. The service access position is shown in Figure 5–3.
WARNING
Do not service the drive unless the safety support is set against the gas
strut shaft.
To close the table-top drive, proceed as follows:
CAUTION
When performing the next step, make sure the cables are secure and are
not pinched.
1. Pull upward on the safety support to disengage it, then lower the deck plate.
2. Raise the top cover and place the cover retainer arm in the recess next to the tape path.
3. Tighten the two retaining screws into the chassis.
4. Fold the cover retaining arm out of the way and close the top cover.
5. Close the enclosure lid by pushing down on the top front corners of the enclosure lid until
the latches lock.
Removal/Replacement Procedures 5–9