Specifications

102
DCS-3950 series Ethernet switch manual
Command mode：Privileged configuration mode.
Example:
Switch# erase logging lastFailureInfo
Relative Command：show logging lastFailureInfo
5.6.4.2 System Log troubleshooting
Please check the following causes if any problem happens when using the system
log：
 Check if the global log switch is on.
 Use the show channel command in the privileged mode to check the state of
each channel and the state of the modules in filter items.
5.7 Classified Configuration
5.7.1 Introduction of Classified Configuration
In order to effectively protect the network, the switch allows users to log on as
different identities to configure it, allows different password for those identities, and allows
those identities to use different rights, when configuring the switch. Right now, DCN switch
provides visitor and admin as configuration levels. Their differences are listed as follows:
Identity to Log On Configuration Rights
visitor Most of show command and ping, traceroute, clear etc.. config
mode is not allowed on this level
admin All of the commands.
5.7.2 Configure the Classified Configuration
5.7.2.1 Classified Configuration Task List
1. Command to enable privileged mode.
2. Set the corresponding password for the identity to log on.
1. Command to enable privileged mode
Command Explanation
Enable [level { visitor | admin }
[<password>]]
To log to the switch in the specified identity
2． Set the corresponding password for the identity to log on.
Command Explanation