User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
28
Deleting a Loop
The JamMan Solo XT uses both internal memory and optional external Micro SD/
SDHC memory cards for the storage of loop files. Loops can be deleted one at a time
to make room for other loops. You can delete loops from both internal memory and
external memory.
WARNING! The deletion of a loop cannot be undone! You should backup any loops you wish to
keep, using the JamManager XT loop librarian management software, before deleting them.
To delete a loop from internal or external memory:
1. Select the desired memory location
using the <UP/DOWN> buttons.
2. Press and hold the <STORE> button
for two seconds until the display
shows ErL then release. The STORE
button LED will begin flashing waiting
for a delete confirmation.
NOTE: If the display shows Eri or ErC,
you have held the <STORE> button too
long and need to press the <PEDAL
SWITCH> to abort the procedure and
start over.
3. Press the <STORE> button again. The
display will read E? (Erase Loop?).
4. To continue with the deletion of the
loop, press and hold the <STORE>
button until the display reads dEL then
release. To abort procedure, press the
<PEDAL SWITCH>.