User Manual
Table Of Contents
- Introduction
- Features
- Quick Start
- Connectors and User Interface
- Connection Diagrams
- Output Jack Operation
- Making Connections and Applying Power
- Teaching Drum Patterns
- Selecting Drum Pattern Settings
- Using Song Parts
- Managing Songs
- Advanced Features and Tips
- Teaching Special Drum Patterns
- Teaching a Difficult Pattern
- Teaching a Pattern with No Kick or Snare on Beat 1
- Teaching a Pattern with No Kick or Snare
- Teaching a Pattern with Kick and Snare on the Same Beat
- Teaching a Half-Time Shuffle Pattern
- Teaching a 6/8 Ballad Pattern
- Teaching a Classic Train Beat Pattern
- Teaching a Typical Brush Swirl Jazz Pattern
- Using JamSync
- Using an FS3X Footswitch
- Factory Reset
- Updating Firmware
- Specifications
18
Selecting Drum Pattern Settings
Selecting Alternate Sounds for the Kick/Snare
The following table shows the alternate kick and snare sounds available for each drum kit:
Drum Kit
ALT Button (Groove/Kit)
LED Off LED Green
E-POP Electronic-Pop Kick 1 and Snare 1 Electronic-Pop Kick 2 and Snare 2
BRUSH Brush Kick and Snare Brush Kick and Tambourine
PERCUSSION Low Timbale and High Timbale Percussion Kick and Snare
POWER Power Kick 1 and Snare 1 Power Kick 2 and Snare 2
CLEAN Clean Kick and Snare Clean Kick and Sidestick
To select alternate sounds for the kick and snare:
1. Select the song part using the VERSE, CHORUS, or BRIDGE button.
2. Press the ALT button next to the GROOVE/KIT encoder to toggle between the options listed in the table
above.
3. Repeat for other song parts, if desired.