User Manual

Chorus (C1-C9)
A Chorus adds a short delay to your signal. The delayed signal is modulated in and
out of tune and then mixed back with the original signal to create a thicker sound, and
stereoimage.UsetheValuebuttonstoselectoneofthenineChorussettings.
Flange (F1-f9)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds
regeneration (or repeats) to the modulating delay. This results in an exaggerated up
anddownsweepingmotiontotheeffect.UsetheValuebuttonstoselectoneofthe
nine Flanger settings.
Phaser (P1-p9)
A phaser splits the incoming signal, and changes the phasing of the signal. The signal
is taken in and out of phase and mixed back in with the original signal. As the phasing
changes, different frequencies get canceled resulting in a warm sort of twisting sound.
UsetheValuebuttonstoselectoneoftheninePhasersettings.
Tremolo (t1-t9)
ATremoloeffectmodulatesthevolumeofthesignalatanevenrate.UsetheValue
buttons to select one of the nine predetermined settings.
Panner (n1-n9)
AnAutoPannermodulatesthesoundfromlefttorightatanevenrate.UsetheValue
buttons to select one of the nine Panner settings.
16