WARRANTY We at DigiTech® are very proud of our products and back-up each one we sell with the following warranty: 1. Please register online at digitech.com within ten days of purchase to validate this warranty. This warranty is valid only in the United States. 2. DigiTech warrants this product, when purchased new from an authorized U.S. DigiTech dealer and used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.
INTRODUCTION Thanks for choosing the DigiTech® FreqOut Natural Feedback Creator pedal. The FreqOut is a revolutionary pedal that adds different feedback harmonics to any guitar signal without coloring the original tone. Enabling the effect boosts a user-selectable harmonic of the input note, creating controlled, natural-sounding feedback sustain through any amp or amp modeler at any volume.
USER INTERFACE 5 2 6 3 7 8 9 1 4 1. Power Connector Connect the recommended power adapter to this jack (see “Specifications” on page 6 FreqOut pedal requires a power adapter for operation. Battery power is not available. ). The 2. Feedback LEDs The middle LED lights to indicate the FreqOut effect is on. When the effect is enabled, the LEDs will light from inside out to display the onset rate of the feedback effect. 3.
NOTE: When the Momentary switch is set to the “ON” position, the FreqOut will use a buffered bypass signal path. When the Momentary switch is set to the “OFF” position, the FreqOut provides a true bypass signal path. 6. Gain & Onset Knobs Gain Knob – Adjusts the amount of feedback gain. Use lower settings for a subtle effect. Use higher settings to increase the feedback/sustain effect. Onset Knob – Determines how long it takes before the feedback grows to full strength.
USING THE HARMONIC TYPES The Harmonic Feedback Types The first five Harmonic Feedback types let you get feedback at a predictable, repeatable frequency. Feedback is selectable at a sub-octave, 1st, 2nd, 3rd, or 5th harmonic, where harmonic is defined as a multiple of your note1s frequency. For example, the 5th harmonic is 5x your note1s frequency (which is actually 2 octaves above a major third interval of the original note).
MAKING CONNECTIONS/APPLYING POWER To connect the FreqOut pedal to your rig: 1. Turn down the amplifier’s master volume control. 2. Make all audio connections to the FreqOut as shown below. 3. Connect the optional power supply to the POWER input connector and connect the other end to an available AC outlet. 4. Strum your guitar and gradually increase your amplifier’s master volume control until the desired level is achieved.
SPECIFICATIONS Electronic Controls: Signal to Noise Ratio: THD: A/D/A Conversion: Input Input Type: Max Input Level: Input Impedance: Output Output Type: Max Output Level: Output Impedance: Feedback, Momentary On/Off, Dry On/Off, Gain, Onset, Type, Effect On/ Off > -106dB (A weighted); ref = max level, 22 kHz bandwidth 0.
WEB: digitech.com SUPPORT: support@digitech.com FreqOut Owner's Manual 5082465-A © 2022 CORTEK Corp. All rights reserved. DigiTech is a registered trademark of CORTEK Corp.