Owner's Manual

2
USER INTERFACE
2
6
5
8
7
4
3
9
1
1. Power Connector
Connect the recommended power adapter to this jack (see “Specifications” on page 6 ). The
FreqOut pedal requires a power adapter for operation. Battery power is not available.
2.
Feedback LEDs
The middle LED lights to indicate the FreqOut eect is on. When the eect is enabled, the LEDs will
light from inside out to display the onset rate of the feedback eect.
3.
Output Jack
Connect this jack to the input of an amp or the input of the next pedal on your pedalboard.
4.
Effect Footswitch
Turns the FreqOut eect on or o. The Eect footswitch can operate as a latching or momentary
switch depending on the position of the Momentary switch.
5.
Momentary Switch
Determines the operation of the Eect footswitch. When set to the “ON” position, the eect will
only be enabled as long as the Eect footswitch is held down. Use this setting to apply feedback only
to certain notes or passages during a performance.
When set to the “OFF” position, the Eect footswitch will operate just like standard eect pedals,
where the eect toggles between enabled and bypassed modes each time the Eect footswitch is
pressed. Use this mode when you want feedback to be more prominent during a performance and
don’t want it to be applied during specic notes or phrases.