Owner's Manual

8
Using JamSync
Connection & Record Sequence
JamSync allows you to synchronize multiple JamSync compatible devices using optional 1/8”
mini stereo (TRS) cables (see below cable diagram)� This allows a JamSync master to control
the loop playback and stop functions for all connected JamSync slaves, providing multi-track
looping capabilities� You can cascade multiple JamMan Express XTs for single-player/multi-
track looping or collaborate with other musicians, each recording and cueing their own
loops for expressive multi-player/multi-track looping�
1/8” Mini Stereo (TRS) Cable Diagram
1/8” Stereo Cable (TRS)
Sleeve (Ground)
Tip
Ring
Tip
Ring Ring
Sleeve
(Ground)
Tip
Sleeve
(Ground)
JamSync
SLAVEMASTER
INOUT To Next JamSync Slave
OUT
Record First Record Second
Optional
JamSync
.
To use JamSync, connect the master device’s
JAMSYNC OUT jack to the JAMSYNC IN jack
of the rst slave device. The
REC and PLAY
LEDs on the slaved device will briey ash,
indicating the unit is in slave mode� Daisy chain
any remaining slaves in the same manner�
When cascading multiple JamMan Express XTs
in series and using JamSync, the last JamMan
Express XT device in the chain should be the
master� You will then want to record to the
last JamMan Expess XT device in the signal
chain (the master) rst, then the second to
last device, etc�, working your way backwards
through the signal chain� Performing these
actions will ensure you record only what you
intend to during each pass�
There are two methods for recording loops to a JamSync slaved JamMan device:
• Manual Slave Recording Method
Using this method, you can record to the master then wait until you’re ready to
record to the slave� This method works well if you do not wish to immediately