Owner`s manual

Selecting a Loop

The JamMan

Stereo has two banks of loop memory, internal and optional

card memory. There are 99 memory locations available in each of these

banks for a total of 198 memories when an optional SD/SDHC memory card

is installed. The card memory bank is only available when a memory card is

installed.

To select loops, Press either the LOOP UP or LOOP DOWN footswitches or use

the LOOP SELECT knob next to the DISPLAY.

Pressing the LOOP UP footswitch will select the next loop above the current

loop. Pressing the LOOP DOWN footswitch will select the previous loop below.

Pressing and holding either of these footswitches will scroll through the loop

memories in its respective direction. The DISPLAY will show the memory

location number as these buttons are pressed.

When Loop 99 is reached, pressing the

LOOP UP footswitch will return to the

ﬁrst memory location (1 will be shown in the display). Likewise, if Loop 1 is

reached, pressing the LOOP DOWN footswitch will return to the last memory

location (99 will be shown in the DISPLAY). If an optional memory card

is installed, pressing the LOOP UP or LOOP DOWN footswitches will alternate

through one bank of memories and then the next (1-99 internal and then

1-99 card). The

CARD MEM LED will light when memories are selected on the

optional external card.

As loops are selected, the

LOOP or SINGLE LED will ﬂash as the loop is loaded

from internal or optional card memory. Trying to store, copy, or change the

loop tempo during this time is ignored (bu will be displayed indicating the

JamMan Stereo is busy loading a loop from memory).