Owner`s manual

The JamMan

Stereo is designed to be very simple to use right out of the box.

This section explains how to record a phrase and play it back as a continuous

loop. You should have an instrument or audio device connected to the 1/4”

inputs or a mic connected to the XLR mic input before proceeding.

NOTE: The maximum loop time the JamMan Stereo can record or play is

10 minutes.

1. Select an empty memory location using the LOOP SELECT knob or the

LOOP UP/LOOP DOWN footswitches (the LOOP and SINGLE LEDs will be off).

2. (Optional) If you would like to perform to a guide track, you must set a

tempo. The rhythm guide track will not be heard until a tempo has been

set. You can set a tempo by tapping the TEMPO/STOP footswitch. Adjust

the RHYTHM LEVEL knob to a suitable volume. The TEMPO/STOP footswitch

will now be ﬂashing at the set tempo (see page 42).

3. (Optional) Set the Time Signature to something other than 4/4, if desired

(see page 40).

4. Press the REC/PLAY/OVERDUB footswitch and begin playing or singing to

start recording. If a tempo has been set, there will be a single measure

count-in indicated by the TEMPO footswitch before recording begins. The

REC/PLAY/OVERDUB footswitch will then light solid red, the LOOP LED

will light, and recording will start. If no tempo has been set, recording

will begin instantly after the REC/PLAY/OVERDUB footswitch is pressed and

you begin playing.

5. When you are ready to set the loop point for your phrase, press the

REC/PLAY/OVERDUB footswitch to set the loop point and have the phrase

play back in a repeating loop. The REC/PLAY/OVERDUB footswitch and

PLAY status LEDs will light solid green.

6. Press the TEMPO/STOP footswitch to stop the loop playback.

Once you are ﬁnished recording, the STORE button will be lit indicating the

phrase must be stored to memory to be recalled later.

Recording a Loop - Inst/Mic Input