User Manual

Deleting a Loop

The JamMan Solo XT uses both internal memory and optional external Micro SD/

SDHC memory cards for the storage of loop ﬁles. Loops can be deleted one at a time

to make room for other loops. You can delete loops from both internal memory and

external memory.

WARNING! The deletion of a loop cannot be undone! You should backup any loops you wish to

keep, using the JamManager XT loop librarian management software, before deleting them.

To delete a loop from internal or external memory:

1. Select the desired memory location

using the <UP/DOWN> buttons.

2. Press and hold the <STORE> button

for two seconds until the display

shows ErL then release. The STORE

button LED will begin ﬂashing waiting

for a delete conﬁrmation.

NOTE: If the display shows Eri or ErC,

you have held the <STORE> button too

long and need to press the <PEDAL

SWITCH> to abort the procedure and

start over.

3. Press the <STORE> button again. The

display will read E? (Erase Loop?).

4. To continue with the deletion of the

loop, press and hold the <STORE>

button until the display reads dEL then

release. To abort procedure, press the

<PEDAL SWITCH>.