Owner`s manual

gatonoff (Noise Gate On/Off) Turns the Noise Gate on and off
gatthres (Noise Gate Threshold) Controls the Noise Gate’s Threshold
gatattak (Noise Gate Attack) Controls the Noise Gate’s Attack time
PLucksNS (Noise Gate Pluck) Controls the Noise Gate’s Pluck Sensitivity
fx onoff (Chorus/Mod On/Off) Turns the Chorus/Mod module on and off
Modulation Effects Parameters
Active Effect
Chorus (Chorus) Speed Depth predelay MOD levl MOD wave mod bal
Flanger
(Flanger) Speed Depth Regen MOD mix MOD wave mod bal
Phaser
(Phaser) Speed Depth Regen MOD levl mOD wave mod bal
Trigflng
(Trig.Flngr.)Speed Senstvty LFO Strt MOD MIX
Trigphas
(Trig.Phsr.) Speed Senstvt LFO Strt MOD MIX
Tremolo
(Tremolo) Speed Depth waveform
panner
(Panner) Speed Depth waveform
vibrato
(Vibrato) Speed Depth waveform
rotary
(Rotary) Speed Depth Doppler mod mix xover MOD bal
autoya
(Auto Ya
™
) Speed Depth RANGE MOD mix MOD bal
yaya
(Ya Ya
™
) yAya PDL Depth RANGE MOD mix MOD bal
synthtlk
(SynthTalk) Attack Release Vox Senstvty mod bal
Envelope
(Env. Fltr.) Senstvty Range MOD Bal MOD MIX
DETUNe
(Detune) Amount MOD Bal MOD LeVL
pitch
(Pitch Shift) SHIFT MOD Bal MOD LeVL
dlyonoff
(Delay On/Off) Turns the Delay module on and off
DLY fdbk (Delay Feedback) Controls the amount of Delay Feedback
threshld (Delay Threshold) Controls the Ducker Threshold for the Delay
duckattn (Ducker Attenuation) Controls the attenuation level applied to the Delay signal
when the Ducker Threshold is exceeded
DLY levl (Delay Level) Controls the Mix Level of the selected Delay Type
DLY BAL (Delay Balance) Controls the left/right balance of the selected Delay Type
*
DLY sprd (Delay Spread) Controls the left/right balance of the selected Delay Type
rvbonoff (Reverb On/Off) Turns the Reverb effect on and of
RVB PRE (Reverb Predelay) Controls the Reverbs Predelay time
rvbdecay (Reverb Decay) Controls the Reverbs Decay time
RVB levl (Reverb Level) Controls the Reverbs Mix Level
RVB BAL (Reverb Balance) Controls the left/right balance of the selected Reverb Type
VOL PRE (Volume Pre) Controls the Volume after the Amp Modeling,but before the
Effects
VOL PoST (Volume Post) Controls the Volume at the end of the Effects chain
LFo1 SPD (LFO 1 Speed) Controls the modulation speed of Expression LFO 1
LFo2 SPD (LFO 2 Speed) Controls the modulation speed of Expression LFO 2
*Delay Balance is replaced by Delay Spread when Spread Delay is selected.
49
Expression Pedal Assignment