User Guide

Procesures
DigiTech S-DISC™ SysEx
RECEIVE RAM AREA (47h)
SYS_HEAD, 47(h), bb, ww, xx, yy, z,z nn, dd(1
st
)
1
, dd(1
st
)
2
, ... dd(nn
th
)
1
, dd(nn
th
)
2
, F7(h)
bb Bank number of RAM being sent. Currently the bank normally used in
these DigiTech devices is 00h.
ww 0000000v(b) where v is bit 15 of the RAM address.
xx 0vvvvvvv
(b) where v is bits 14 - 8 of the RAM address.
yy 0000000v(b) where v is bit 7 of the RAM address.
zz 0vvvvvvv
(b) where v is bits 6 - 0 of the RAM address.
nn 01(h)
to 7F(h), the number of RAM data bytes in this response.
dd(c)
1
0000000v(b) where v is bit 7 of the c
th
byte being sent.
dd(c)
2
0vvvvvvv(b) where v is bits 6 through 0 of the c
th
byte being sent.
The Receive RAM Area procedures are used to load an area of a DigiTech device’s
internal RAM from a host MIDI device. Use the information in the Receive
Configuration Address procedure to identify the RAM locations which may be
accessed from the various products. The product will also perform an equivilant to a
Receive Reset Program procedure.
REQ
UEST MODULE TABLE (50h)
SYS_HEAD, 50(h)
, F7(h)
When a Request Module Table procedure is received, the DigiTech device will respond
with a Respond Module Table procedure.
10
10
Procedures
DigiTech S-DISC™ SysEx