User Guide

DATA RESPONSE (10h)
SYS_HEAD, 10(h), bb, ww, xx, yy, z,z nn, dd(1
st
)
1
, dd(1
st
)
2
, ... dd(c
th
)
1
, dd(c
th
)
2
, F7(h)
bb Bank number of ram being sent. Currently the bank normally used in
these DigiTech devices is 00h.
ww 0000000v(b) where v is bit 15 of the ram address.
xx 0vvvvvvv
(b) where v is bits 14 - 8 of the ram address.
yy 0000000v(b) where v is bit 7 of the ram address.
zz 0vvvvvvv
(b) where v is bits 6 - 0 of the ram address.
nn 01(h)
to 7F(h), the number of ram bytes in this response.
dd(c)
1
0000000v(b) where v is bit 7 of the c
th
byte being sent.
dd(c)
2
0vvvvvvv(b) where v is bits 6 through 0 of the c
th
byte being sent.
The Data Response procedure is sent from a DigiTech device in response to a Request
RAM Area procedure. See the Misc Information
(page 19) for the mapped descriptions
of the information in this data packet. If a Data Response procedure is received by a
DigiTech device, it is ignored. However, this data could be configured for use with the
Receive RAM Area procedure.
RESET PROGRAM (20h)
SYS_HEAD, 20(h)
, F7(h)
The Reset Program procedure causes the DigiTech product to reload the current saved
program and reload the fast program cache.
RESET DEVICE (21h)
SYS_HEAD, 21(h), F7(h)
The Reset Device procedure causes the DigiTech device to reboot the software as if the
power had been turned off and then back on. If edits have been made to the current
program without saving, they will be lost.
DigiTech S-DISC™ SysEx
Procedures
7
7
Procedures
DigiTech S-DISC™ SysEx