Inc Sound Module Decoder - Manual

www.digitrax.com- 17 -

Digitrax FX

functions incorporate up to 8 FX generators that can be custom-

ized. These FX

function outputs can be mapped so they are controlled by any

function key on your throttle. A master light switch can be set up to turn off

all lights on a locomotive. Functions associated with advanced consists can be

controlled, too.

Function outputs on Digitrax decoders are available in several current ratings

depending on the decoder. These ratings are the total current available for

activating and running the devices attached to ALL the function outputs on the

decoder. Check your specific decoder’s specifications for the function current

rating for your decoder.

3.3.7 SoundFX Decoders

Sound inside your locomotive is another factor to consider in decoder selection.

Because sound installation requires additional space inside the locomotive for

installing a hold up capacitor and a speaker with baffle, this must be considered

during decoder selection.

3.4 Read the Instructions

Digitrax decoders are shipped with individual instruction sheets. These have

specific instructions for each particular decoder. These are also available on-

line along with installations that demonstrate how to do many different decoder

installations.

3.5 Plan the Installation

Planning ahead will make decoder installation easier to do.

3.6 Have the Proper Tools At Hand

You’ll need a few simple tools when you begin installing decoders:

1. A temperature controlled low wattage soldering iron. Though many

installations do not require soldering, you may need to use a solder-

ing iron to install LEDs and lamps for special lighting effects.

2. 0.015”-.032” rosin core solder for electronics

3. Small screwdrivers and small shims for disassembling your loco.

4. Small diagonal cutters for cutting & stripping small wire.

5. Tweezers to pick up small loco parts.

6. Heat shrink tubing for protecting wire connections, electrical tape is

NOT recommended.

7. Tape for securing wires and the decoder inside the locomotive.

Digitrax provides Kapton tape with many decoders for electrically

insulating the locomotive frame.

8. Decoder installation should be done in a static free environment on a

non-metallic surface.