Inc LocoNet Cable Maker Kit - Manual

© 2020 Digitrax, Inc. www.digitrax.com— 2 —
Step 1: Cut Cable to Length
Cut the LocoNet cable to the desired
length. Make sure that the ends are cut
squarely, not diagonally.
Step 2: Insert Cable Into
Stripper
Insert the cable between the stripper
blades until it touches the stop.
Step 3: Strip Cable
Squeeze the handle and pull the tool
keeping the cable perpendicular to
strip o outer insulation without dam-
aging the insulation on the inner wires.
Step 4: Position RJ12 Plug and
prepared cable.
Place an RJ12 modular plug in the
holder. Insert prepared cable insuring
the inner wires are ush with the tip of
the connector.
Step 5: Press FIRMLY to
Crimp
Make sure the plug and cable are
properly aligned before crimping.
Squeeze the handles FIRMLY to set the
contacts and secure the cable.
Step 6: Repeat on other end
and test cable
Once the crimp on both ends is com-
pleted as shown, test using an LT1
prior to installing on your layout.
Tab “up”
Tab “down”