Installation Guide

3
Rear Panel
The rear panel view of the Switch consists of an AC power connector.
Grounding:
use specialized ground lead connect
Connect
the power adapter output terminal to this port.
Supports input voltages
100 – 240 V AC
3. Hardware installation
This chapter provides unpacking and installation information for the Ethernet Switch.
Package Content
Open the shipping carton and carefully unpack its contents. Please consult the
packing list located in the QIG to make sure all items are present and undamaged. If
any item is missing or damaged, please contact the local reseller for replacement.
• Switch 1pcs
• AC power cord 1pcs
• QIG 1pcs
Switch Installation
For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the AC power
connector. Make sure that there is proper heat dissipation and adequate ventilation
around the switch. Do not place heavy objects on the switch.
Installation Hole Spacing
INPUT: 100 -240 V AC
10 mm
235 mm