4K HDMI Extender Set over IP/CAT User Manual DS-55124 • DS-55125 (RX unit) Rev.
Important Safety notice Please read below safety instructions carefully before installation and operation: 1. 2. 3. 4. Please pay attention to all the warnings and hints on this device Do not expose this unit to rain, moisture and liquid Do not put any stuff into the device Do not repair or open this device without professional people’s guidance 5.
Package Contents HDMI EXTENDER sender TX x1pcs HDMI EXTENDER receiver RX x1pcs IR OUT IR blaster extension cable*1pcs User Manual x1pcs IR IN IR receiver extension cable*1pcs Installation Requirements 1. HDMI source device (computer graphics card, DVD, PS3, HD monitoring equipment etc.). 2. HDMI display device like SDTV, HDTV, and projector with HDMI port. 3. Network cables: CAT 5/5e/6 network cables 4. Transmission length: CAT5 80m/CAT5E 100m/CAT6 120m 5.
Panel Description 1. HDMI EXTENDER TX (Sender) ① Reset ⑤ Power input (DC5V) ② HDMI signal input ⑥ Data transmission light ③ IR signal output to connect ⑦ Network link light with blaster extension cable ⑧ HDbitT signal output (PoE Input) ④ Power Light 2.
Installation Procedures 1. Connections 1.1. Point to Point connection: Up to 120 meters transmission distance over single CAT6 (High quality cable can reach 150 meters) DVD HDMI EXTENDER TX (Sender) HDMI IN HDMI EXTENDER RX (Receiver) HDMI OUT PoE Switch CAT5/5E/6 Cable TV 1.2. Router Connection: By using network router/repeater, realize unlimited extension.
1.3. One-to-many Connection: By using network router/switch, one sender to several receivers, realize extender & splitter function.
Specification Product type feature 4Kx2K HDMI over IP CAT5/5e/6 Extender with PoE Up to 120m, support one to many, 4K@30Hz Max transmission rate Color Depth 10.2Gbps 8bit 480i@60Hz, 480p@60Hz, 576i@50Hz, 576p@50Hz, Supported video resolution 720p@50/60Hz, 1080i@50/60Hz, 1080p@50/60Hz, 4K×2K@24/25/30Hz Supported audio formats LPCM HDMI connector Type A, Female, 19-pin RJ45 Connector RJ45 Latency <220ms Input and Output TMDS signal 0.7~1.
used) is connected, and make sure connecting cable is firmly. Q: TV display “Please check the TX input signal”? A: Please check if there is a HDMI signal input of TX Try to connect the signal source directly to display device to see if there is signal output from source device or change the signal source, HDMI wire and try again Q: When playing 4Kx2K source, screen is back without any content? A: Make sure both TV and HDMI cable support HDMI1.4.
