User Manual USB2.
I. Foreword Congratulations on your purchase of our product! We will show you a new storage concept with safety and convenience. It is our pleasure to give you the best solution to expand your HDD'S Capacity and enhance your data's reliability in PC system or Mac system. Before using the product, please read this manual carefully for further recognizing of the product. II.
4pin Power C USB2.0 Power Plug(red) Power/Activity-LED (blue & red) USB2.0 Plug SATA Plug for SATA device 44-pin IDE plug for 1.8/2.5 IDE HDD 40-pin IDE plug for 3.5/5.25 IDE device Note: For 3.5/5.25 IDE devices, please plug in a 5V/12V power supply (not included) to appropriate port on the back side of HDD or DVD, so that the PC power switch (on/off) can’t control the current to HDD or DVD. If you want to cut off the current to HDD or DVD, then you need to plug out the power plug from 3.
V. Hardware installation a. Connect to a 2.5 SATA HDD SATA Plug b. Connect to a LED 2.5 IDE HDD LED 44pin IDE Plug For a 2.5 SATA HDD or IDE HDD, plug directly the SATA connector or the 44pin connector into the appropriate ports on the rear of the HDD, and plug the USB signal/data plug (Black) into USB port of PC. Note: If you HDD need more than 500mA, please plug the USB extra power plug (Red) additionally into other USB port.
c. Connect to a 3.5 SATA HDD 3.5 SATA HDD 5V/12V Power supply (Please see chapter VIII. How to use power supply from your desktop computer). Alternatively, you can use 5V/12V external power supply d. Connect to a 3.5 IDE HDD 3.5 IDE HDD 5V/12V Power supply LED For a 3.5 SATA HDD or a 3.
e. Connect to a 5.25 IDE HDD 5V/12V Power supply For a 5.25 CD/DVD device, plug directly the 40pin connector into the appropriate ports on the rear of the CD/DVD device, and plug the USB signal/data plug (Black) into USB port of PC, then plug the 4-pin plug of the power supply to the 4-pin power jack (for IDE CD/DVD direct plug in CD/DVD power connector), and the other end plug to power source. VI. Driver installation a.
VII. Under the following situation, you need to use 5V/12V Power supply 1) When connects with the 3.5 / 5.25 SATA devices ( HDD, CD ROM , DVD Rom ) 2) When this product connect with 3.5 / 5.25 IDE devices ( HDD , CD Rom , DVD Rom ) 3) Connecting with the 2.5 SATA HD, when the power consumption is bigger than 1A 4) Connecting with the 1.8 / 2.
VIII. How to use the device with power supply from computer 1. Plug DA-70202 into USB port 2. Plug 3,5HDD into the correspondent port ( SATA/IDE) 3. Plug the power for supplying mentioned devices in Point VII.
Also, for 5,25 devices Connect from the 4 pin power connector of the power supply to DA-70202 (4Pin DC) Power supply 10
Disclaimer All the information in this document is subject to change without prior notice. The manufacturer makes no representations or any warranties regarding the Contents of this manual. The information contained in this manual is provided for the general use by the customers. No part of this document may be reproduced or transmitted in any form by any means without the express written permission of The manufacturer.