Datasheet

59
Services (NIS) in your system, you may need to rebuild
the NIS map with the BOOTP services before doing the
following BOOTP configuration. To rebuild the NIS
map, please refer to your system documentation.
To configure the IP address data for the BOOTP
server, you will need to log in the host of BOOTP
server as the superuser (root). Perform the following
steps to add address entries,
1. Optionally, assign a name corresponding to the
print server’s IP address. You can add this address to
the /etc/hosts file, by adding a line such as:
203.66.191.12 pserver
2. Add an entry to the host’s /etc/bootptab file,
similar to the following:
hostname:\
:ht=1:\
:ha=print_server_ethernet_address:\
:ip=print_server_ip_address:
Lines should be indented with tabs.
Where hostname is the device name of a print
server, the ht=1 tag specifies the hardware type is
Ethernet, the ha= tag specifies the Ethernet address of
a print server, which is the Node ID located on the
print server. The ha tag must be preceded by the ht
tag. The ip= tag should correspond to the IP address
you want to assign to the print server.