Datasheet

Note that before you upgrade the firmware please

make sure that the IP Address settings of the MFP

Server are in the same network as your computer.

Load Default: If you want to reset the Print Server

to default factory settings, please click “Load Default”.

Wireless Function: You can select “Enable” or

“Disable” to manually enable or disable the wireless

function. If you manually enable wireless function, the

print server’s wireless LAN will be always enabled and

Ethernet will be always disabled. If you manually

disable the wireless function, the print server’s

wireless LAN will be always disabled and Ethernet will

be always enabled. You also can select “Auto” to let

the print server automatically decide to enable or

disable the wireless function. The print server only can

work in ether Ethernet or wireless LAN mode. It cannot

work in both Ethernet and wireless LAN mode at the

same time. When the print server starts up, it will auto-

detect if the LAN port is connected to an active

network by an Ethernet cable. If the print server is

connected to an active network by Ethernet cable

when starting up, the print server will run in Ethernet

mode. If the print server is not connected to an active

network by Ethernet cable when starting up, the print

server will run in wireless LAN mode. The print server

default is in “Auto” mode.