Datasheet

address automatically. The IP address will then appear on the Control Center
or on the page of configuration report that you printed earlier. If your DHCP
server does not give an IP address to the Server, the Server will use the
Factory IP address: 192.168.1.100.
 If you are not working in a DHCP network, you need to manually set the
Server’s IP address.
3.3.2 Ethernet Address
You do not need to know the Ethernet address of your Server for assigning an IP
address to it. The Control Center can automatically search Servers and list their
Ethernet addresses. Besides, you can find Ethernet address that is located on the
backside label of the Server.
3.3.3 IP Address
Unless you are assigning an IP address using DHCP, you must obtain an unused IP
address from your network administrator.
3.3.4 Methods for Setting the IP Address
You can set the IP address of your Server using one of the following methods,
depending on your network operating environment:
 Automatic IP Address Assignment
 Manual IP Address Assignment
3.3.5 Host Names and Host Name Rules
The Host Name of the Server defaults to be “DN-13005” (for DN-13015) or
“DN-13005” (for DN-13015). If you put two or more Servers in your local area
network, to avoid using the same Host Names you have to change the Host Names by
using the Control Center or the Server’s web pages. If your Host Name is longer than
15 characters, the Server uses only the first 15 characters.
3.3.6 Setting the IP Address Using DHCP
Follow the instructions below to get an IP address using DHCP:
1. Edit or create a scope in the DHCP manager of the DHCP daemon. The entries
included in this scope should contain the following parameters:
y range of IP addresses
y subnet mask
y default router IP address
y DNS server IP address
y lease duration
2. Activate the scope. The Server automatically gets the DHCP parameters. If you
are using DNS, you may include at least one DNS server IP address in the DHCP
scope or manually set the DNS server IP address using Server’s web pages or
17