Instructions

33
Chapter 7 Restore Factory Defaults
You may restore the Server’s default parameters by one of the following methods.
1. Please power on the device. Make sure this USB 2.0 Multifunction
Network Server can be found by the utility first.
2. Then press the “Init” button for 10 seconds and then release it.
3. Wait for 3~5 seconds, all the LEDs (USB/LAN/WLAN) except Power LED will be off
(in order to see the LED going off as indication of factory default, it is suggest to plug in
Ethernet cable or USB pen drive to the device first before pressing the init button).
4. Then after another 3~5 seconds, the LEDs (USB/LAN) will be ON again.
Then this means the device is applied with factory default.
7.1 Using the Server’s Web Pages
1. Go to the Server’s web page and click CONFIG
2. Enter administrator (default: admin) and password (default: admin).
3. Click Maintenance.
4. Click Factory Default.
5. Click Yes to confirm