Instructions

11. Click Submit to save your settings. And the server will reboot.

12. You have now finished the procedure of setting the wireless parameters.

After properly configuring the wireless parameters, you can remove the network cable and

reboot the DN-13023. DN-13023 will then connect to your wireless network. DN-13023 will

detect if a network cable is plugged-in or not. If a network cable is plugged-in, DN-13023 will

always connect to the network through the network cable. Otherwise it will always connect to

the network through wireless module. Once DN-13023 connects to the network, either by

network cable or by wireless module, all operations to use USB device server are exactly the

same.

2.3 Assigning an IP Address to the Server

2.3.1 Preliminary

 If you have a DHCP server on your network, your Server will receive an IP address

automatically. The IP address will then appear on the Control Center or on the page of

configuration report that you printed earlier. If your DHCP server does not give an IP

address to the Server, the Server will use the automatic private IP addressing IP:

169.254.0.0. ~ 169.254.255.255

 If you are not working in a DHCP network, you need to manually set the Server’s IP

address.