Instructions

F. Click the “Connect” button. Then the message “Manually Connect by
your_computer_name” will be shown, as Fig5.
Figure 5 Device Connected
G. Now, the installation program will detect the USB device and continue
to install driver.
H. After the installation is completed, click the USB device in the Control
Center and then click the “Disconnect” button to disconnect the USB
device.
 Use the USB Device
A. In the Control Center, click the USB device server that has the desired
USB device attached.
B. Click the desired USB device as Fig 4.
C. Click the “Connect” button. Then the message “Manually Connect by
your_computer_name” will be shown, as Fig 5.
D. Now, PC will detect the plug-in of the USB device. The “connect”
operation is a software operation that simulates an actual USB device
plug-in. That is to say, when you do a “connect” operation in the
Control Center, PC can then detect a USB device’s plug-in, although
actually you do not plug in any USB device.
E. Then, just use the USB device as if it is connected directly to your PC’s
USB port.
F. After you finish using the USB device, click the USB device in the
Control Center and then click the “Disconnect” button to disconnect
the USB device, as Fig 6. Other PCs can not “Connect” the USB
device until you “Disconnect” that USB device. That is to say, only one
PC is allowed to connect the USB device at the same time.