User manual

Plug&View IP camera ׀ Manual ׀ EN-201310 10
5.4.5 Motion Detection
Enable the motion detection with a click on "On".
The colored area within the video image is the
motion detection area, i.e. the area in which a
movement triggers a picture or a video recording.
In the original delivery condition, almost the entire
screen is covered with red boxes. In order to
exclude certain areas from the motion detection,
clickin the bottom right cornerof the colored
marker and move the mouse towards the top
left, while holding the mouse key down.
By doing this, you delete the marker for that area. Respectively, you do the same in the opposite
direction, from top left to bottom right, to select a new area for motion detection. The sensitivity
ranges from 0 to 5, whereby the smallest value represents the highest sensitivity. The typical setting
is 3. The value behind "next motion detection after..." specifies after how many frames the motion
detection will be triggered again. By clicking on "OK" you complete the setting and will then receive a
message in a pop-up window, to set the 'Action' next, which should start as soon as the camera
registers a movement within the range. Confirm with "OK" and you will be automatically moved to the
"Alarm Setting".