User manual

Plug&View IP camera ׀ Manual ׀ EN-201310 11
5.4.6 Alarm
There are three types of alarm setting: Motion detection, Alarm in (external alarm) and Time. To
activate the motion detection, click on the tab with the corresponding name. Please make the
settings under the right-hand menu "Motion Detection" first, as long as the coverage and the
sensitivity have not yet been set, as described in 6.1.5. Select the time frames for the motion
detection with the left mouse button in the time grid. Click on "Enable" and on "Record" to save the
video recording, which was triggered through motion detection, on the microSD card. You can also
setup e-mail notification of motion detection, as described below. By activating "Capture", a snapshot
will be triggered in the event of motion detection. This image will then be automatically sent to you as
an attachment with the e-mail notification.
Storing your videos/pictures on an FTP-server is also possible. Please enable FTP and press "Set
FTP" to enter your credentials. This function will then transfer all videos and pictures from the
microSD card to your FTP-server.
Enabling "DO Out" triggers a switch contact in the event of motion detection, which can be forwarded
to an alarm system via an external port of the camera (e.g. Plug&View Optiarc).
In the tab "Alarm In" the recording can be triggered externally through a passive switch contact, e.g.
a window or door sensor. Your camera must be equipped with an external connector (e.g. Plug&View
Optiarc) to be able to connect a suitable cable, through which the "Record", or "Capture" will be
triggered.