Specifications

DIGITUS
®
KVM Switch Module for modular based TFT consoles
22
g To select a computer by hotkey command, you must know its port number, which
is determined by the DIGITUS® KVM Switch Module connection. For a
computer connected to a Master, its port is represented by the PC port label (1~8
or A~H). For a computer connected to a Slave, two characters represent its
port. The first character is the port number of the Master unit (1~8) and the
second one is the port number of the Slave (1~8 or A~H). Please note that only
Master's 'PC 1' ~'PC 8' ports can be connected to a Slave.
Left Ctrl + left Ctrl + 7
Selects a computer connected to port 7 of the Master.
Left Ctrl + left Ctrl + 6 + C
Selects a computer connected to port C of a Slave connected to port 6 of the
Master.
g To start Auto Scan, automatically scan power-on computers one by one at a fixed
interval:
Left Ctrl + left Ctrl + F1
When Auto Scan detects any keyboard or mouse activity, it suspends the scanning
till activity stops; it then resumes with the next computer in sequence. The length
of the Auto Scan interval (Scan Rate) is adjustable, see below. To abort the Auto
Scan mode, press the left Ctrl key twice.
Note: Scan Type determines whether an eye-marked computer is to be displayed
during Auto Scan.
g Manual Scan enables you to manually switch back and forth between power-on
computers.
Left Ctrl + left Ctrl + F2
Press “ é ” or “ ê ” to select the previous or the next computer in sequence. And,
press any other key to abort the Manual Scan.
Note: Scan Type determines whether an eye-marked computer is to be displayed
during Auto Scan.
g To adjust Scan Rate, setting the duration before switching to the next computer in
Auto Scan:
Left Ctrl + left Ctrl + F3
The DIGITUS® sends one to four beeps indicating scan interval of 3, 8, 15, and 30
seconds respectively.
g To adjust keyboard typematic rate (characters/sec), this setting over-rides that of