User manual

5. Port selection
The number keys 1~8 individually correspond to the computers 1~8. Switch computer by pressing number keys or left/right arrows. The number selected will be shown on screen if applied OSD function. If an “x+ number” displayed on screen, it means the corresponding computer is not on line.
6. How to change battery? Please use the battery model “CR2025”. 6-1. Push the hook to right. 6-2. Pull the battery holder out. 6-3. Put the battery up-side on holder then push the holder back. Installation Please make sure that video selector & monitor (projector) are off before beginning installation. 1. Make sure all equipment are turned off. 2. Plug the monitor cable to video connector of selector. 3. Plug the extension cables of VGA port on computer to
CPU port connector of selector.
4. Put the power adapter plug in wall socket. 5. Connect power adapter with the video selector. 6. The red LEDs will flash back and forth. If not, please
go back to check step 4&5.
7. Power on PC & monitor. 8. The green on line LED lights while the computer has
been well connected with the corresponding port & is running.
9. About the change of battery, please refer “how to
change battery” in the previous introduction of “remote controller”.
Operation 2 ways available as below: 1. Manual Port selection Press the button of “port selection switch” to shift to
the computers wanted.
The selected corresponding port will light red to
indicate which port is active.
2. Remote control Port selection
Switch computer by pressing number keys or right/left
arrow (forward/backward).
The selected corresponding port will light red to
indicate which port is active. OSD function
Show you the active port on screen. Press OSD
on/off key on remote controller to enable or disable OSD function. The computer number will be displayed on the left top of screen while you apply OSD.
Scan mode function
Watch the status of all on-line PCs. Press the scan mode on/off key on remote controller to enable or disable auto scan function. Auto-scan time can be increased progressively from every 5 seconds to 30 seconds by pressing up arrow. Conversely, pressing down-arrow makes the time decreased from 30 seconds to 5 seconds. Up/down arrows (forward/backward) work only if auto scan function applied. You are not allowed to switch computer until auto scan function removed. Power on/off function is not limited by scan mode. Power on/off
Turn the video selector on or off. All the LEDs will be off when you turn off the video selector. If restart video selector, the video selector will stay in the last status prior to selector off.
Trademarks: All the companies, brand names, and product names referred to this manual are the trademarks or registered trademarks belonging to their respective companies. For batteries: Please recycle only completely discharged batteries.