User manual

Chapter 2: Card Installation
Hardware Installation
1. Now that you are acquainted with the cards, power down your
computer and unplug it from its power source.
2. Attach a static strap to your wrist and open the case.
3. Remove the bracket place holder and insert the card into a PCI
Express slot. See Figure 11 for an example of card installation.
Figure 11: Insert the Card
4. Replace the cover to your computer.
5. Plug all T1 or E1 equipment cables and dongles into the RJ45 ports as
needed.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord (e.g. for
Australia use only line cords complying with AS/CA
S008:2010).
Digium, Inc. Page 32