Manual

9
Use the directional keys to move around in the User Menu Chart.
1. To move to a new “A” heading, use the TARE (left) or PRINT (right) key to move
right or left in the User Menu Chart.
2. To move to the selection level, press the ZERO (down) key once. The current saved
selection is shown.
3. To view the available selections for the current “A” heading, use the TARE (left) or
PRINT(right) key to move through the selection field.
4. To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current “A” heading.
5. Repeat Steps 2 through 5 until the User Menu is programmed.
SET
User Menu Chart
A1
Baud Rate
A2
Data Bits,Parity
A3
Transmission Mode
A4
Display Check
A5
Enable lb/kg Key
1200 2400 4800 9600
8n 7O 7E 7N
C d
Press ZERO
key to begin
0 1
A6
Serial Port Mode
A7
ID No. Enable
A8
ID No. Entry
A9
No. of Line Feeds
Press ZERO
key to begin
Press ZERO
key to begin
0 10 1
Setup Menu Descriptions
This section provides more detailed descriptions of the selections found in the Setup
Menu Chart. Factory-set defaults are shown in bold with a checkmark (√).