Manual

EDjunior Dynamometer User Instructions 11
4 Power On and Annunciators
When you power up the EDjr you will see a display similar to the example shown on
the left in Figure 4.1.
Figure 4.1 Initial displays
The display sample above shows several symbols you may see on your display but
usually not all at the same time.
Force This tells you that the display is showing live force measurement at the
moment. Will show Peak when viewing Peak Mode.
lbf Current unit of measure is lbf in this example. May also be kgf or N. See
note below.
~ Motion symbol. This appears when the force is in motion. This symbol
disappears when motion ceases.
Battery annunciator. This shows approximate remaining battery life.
Capture of a new peak value. This annunciator will remain lit for a few
seconds.
Force
Force
lbf lbf
00
Clear
Mode ConfigSetupUnits
Arrow key
press
ESC key
press
Depending on permission settings and/or revision of firmware, various soft keys may
be in a different location or not visible.
P
lbf and kgf are units of force, not weight.