Aquatic Fitness System Owner's Manual

Aquatic Fitness System
2002 Owner’s Manual
13
b) Water Condition: Total Alkalinity below 80 ppm
Add 4 ounces of Dimension One Spas -- pH/Alkalinity Increaser (Sodium Hydrogen Carbonate)
with the jets turned on high speed. Continue running jets on high speed for at least 5 minutes. Turn
jets off, retest and repeat procedure until the TA reads close to 80 ppm.
When Total Alkalinity is below 80 ppm the pH will change faster than the Total Alkalinity.
c) Water Condition: pH above 7.8
First, test and adjust Total Alkalinity per the above instructions then test and balance the pH. Add 1
ounce of Dimension One Spas -- pH/Alkalinity Decreaser with the jets turned to high speed.
Continue running jets on high for at least 5 minutes. Turn jets off, retest and repeat procedure until
the pH reads between 7.2 – 7.8.
d) Water Condition: pH below 7.2
First, test and adjust Total Alkalinity per the above instructions then test and balance the pH. Add 1
ounce of Dimension One Spas -- pH/Alkalinity Increaser with the jets turned to high speed.
Continue running jets on high for at least 5 minutes. Turn jets off, retest and repeat procedure until
the pH reads between 7.2 – 7.8.
Two tablespoons are approximately equal to one ounce and three teaspoons are approximately
equal to one tablespoon.
3) Add Sanitizer.
a) If using Chlorine, add the 2oz. packet of Chlorine included with the Aquatic Fitness System’s
owner’s kit. Run jets on high for at least 5 minutes. Monitor Chlorine level with Dimension One
Spas -- Spa Test Strips (available in Dimension One Spas -- Chlorine Spa Starter Kit) and
maintain a residual of 1 – 3 ppm.
4) After day one, shock the water with 2oz. of Dimension One Spas -- Shock Treatment (Potassium
Monopersulfate) with jets running on high speed. Continue running jets on high speed for at least 5
minutes.
5) After day two, add Dimension One Spas -- Enzyme Formula to reduce water line build-up normally
associated with body oils. Run jets on high speed for at least 5 minutes.