Aquatic Fitness System Owner's Manual

Aquatic Fitness System
Glossary of Terms
24
Term (Cont.) Definition
Gfci-Ground Fault Circuit
Interrupter
A type of Circuit Breaker that automatically disconnects power to
the Aquatic Fitness System when there is an electrical power
leakage to ground.
Gravity Drain Valve Used to drain your Aquatic Fitness System.
Halogens
Free chlorine, bromine or iodine ions that are very strong oxidizers
used to sanitize water.
Heater
An 11kw 230v thermostatically controlled electric heater equipped
with a high-limit temperature safety shut-off switch. If the high-limit
switch trips, it can be reset by pressing button on the Top Side
Control, but only when the temperature within the heater assembly
drops to 110
o
F. If the high-limit safety switch trips repeatedly,
contact your authorized Aquatic Fitness System Dealer.
Jets Return the water into the Aquatic Fitness System from the
equipment. The HydroTherapy Jets produce a turbulent flow of
water mixed with air to provide a concentrated body massage. The
Swim Jets produce a high volume flow to provide a rapid current for
swimming.
Light Illuminates the Aquatic Fitness System vessel.
Load Sharing
When the circuit breaker size is smaller than the total power
needed to operate both the heater and the jet pump at the same
time, load sharing automatically turns off the heater when a jet
pump is turned onto high speed.
Lock-Ring
Mechanism that affixes filter cover to filter housing. To remove
cover, turn lock-ring counter-clockwise until it disengages with filter
housing. When replacing the filter cover, turn lock-wring clockwise
to firmly secure the cover.
Ozone Generator
A specialized ultraviolet light that changes oxygen into ozone for use
in the water sanitation process.
Pressure Switch
Safety device(s) that sends a signal to the electronic control system
that there is adequate water flow to turn the heater on.
Primary Pump Produces water flow through the heater, filter, sanitation
system and the main jets in the Aquatic Fitness System. The
primary pump will operate automatically during filtration and
heat cycles. This pump can also me operated manually by
depressing the “jets” button on the topside control panel which
will allow you to choose between two speeds
• Low speed for efficient water circulation during heating
and filtration modes, and for gentle jet resistance or
massage action.
• High speed for maximum jet action.