Project Ideas

Pipes-and-Fittings DIY Bar Cart
YOU WILL NEED
1 – Dimensions
TM
3/4” x 2’ x 4’
birch plywood project panel
cut into three 24” x 16” sections
4 – 3/8” x 24” threaded rods
16 - 3/8” nuts
7’ of 3/4” black steel pipe (or
furniture-grade PVC) cut to four
14” lengths and four 7” lengths
1 – 3/4” x 15.5” black steel pipe nipples
2 – 3/4” x 10” black steel pipe nipples
4 – 3/4” x 2” black steel pipe nipples
2 – 3/4” black iron 90˚
FPT x FPT elbows
2 – 3/4” black iron threaded tees
4 – 3/4 in. black iron 90°
FPT x MPT street elbows
4 – 3/4” black iron FPT floor flanges
16 - 3/4” black screws
4 – 4” general-duty rubber swivel
caster wheels with brakes
16 - 3/4” slotted hex washer head
sheet metal screws
Denatured alcohol and a soft rag
for cleaning pipes and fittings
Optional: Clear polyurethane,
paint or stain of your choice
(Project Plans cont. on pg. 2)
Let’s get started!
STEP 1
Using a tape measure, mark the cuts needed to your 2’ x 4’ project
panel as indicted in the gray box to the left. Make your cuts using a
table saw or follow the tip below. Then use the rest of the list on the left
to gather all remaining items needed to complete your project.
TIP: If the store where you buy your panels offers complimentary
cutting, bring this plan with you and ask them to make your cuts.
DIY PROJECT PLANS
page 1 of 7